If the belt slippage occurs in the folder gluer, how should we solve it?
1. If the starting speed is too fast, the belt of the folder gluer may slip. In this case, the starting speed can be adjusted appropriately, and a slow start can be used. This can prevent slippage to a small extent.
2. Make sure that the load of the folder gluer does not exceed the limit. If the load exceeds the capacity of the motor and exceeds the capacity of the motor, slippage is likely to occur, but at this time the motor can be protected by slippage, but within a large load range, the feed amount can be adjusted to maintain the state of material slippage. This situation is relatively rare.
3. Check the tension of the folder gluer. Insufficient roller tension can cause slippage. In response to this problem, customers need to modify the tensioning device in time to increase the initial tension of the belt.
4. Slippage caused by insufficient friction between the drive roller and the conveyor belt must be eliminated. This is usually caused by the presence of water on the conveyor belt or in a humid environment. You can use a blower to blow rosin powder onto the photosensitive drum.
